Process loads do not follow office hours, so a chiller sized for people can be caught out by equipment running into the evening. We separate the two loads where possible, check water treatment and strainers, and clean condensers that are sitting in a dusty yard. Readings taken over a working day tell you far more than a single spot check.
What that means in practice
- Process and comfort loads assessed separately
- Water treatment and strainer checks
- Condenser cleaning in dusty yards
- Readings taken across a working day
The service behind it
A chiller serves a whole building through water rather than a single room, so when it stops, everything stops. In the office and medical buildings along this territory's main roads, the plant is often a small air-cooled chiller on a roof or in a service yard, feeding fan coils through pipework that nobody has looked at since commissioning.
Read the full chillers pageQuestions
The chiller trips on hot afternoons. Why?
Usually high ambient at a dirty condenser, or a refrigerant charge that is no longer right. Both show up in the pressures. We measure before touching the controls, because a reset that hides the fault will not last the summer.
Do you take on maintenance of an existing chiller?
Yes. We start with a condition survey and a set of operating readings, then set an interval from the plant's condition and the building's hours. You get the survey findings before any contract starts.
Our building cools unevenly. Is the chiller too small?
Not necessarily. Uneven cooling on a chilled-water system is usually balancing, flow or control related rather than capacity. We measure flow and temperatures at the fan coils before discussing a larger chiller.