Service 04

Cold Room Installation & Repairs

Walk-in cold rooms for restaurants, school kitchens and food shops: panels, doors, condensing units, controls, servicing and repairs.

A cold room is a small building as much as it is a machine. The panels, the floor, the door, the vapour seal and the refrigeration plant all have to work together. Get the panel joints or the floor detail wrong and the room runs constantly, drips from the ceiling and damages the stock it was built to protect.

In this territory most rooms are retrofits into spaces that were never designed for them: a back room behind a Claremont cafe, a converted store in a Mowbray terrace, a residence kitchen in Rondebosch. We size on the product load and the way the room is actually used, how often the door opens, what goes in warm, how much stock turns over in a week, then match evaporator, condensing unit and defrost strategy to that duty.

What the work covers

  • New walk-in cold rooms, panels through to commissioning
  • Condensing unit and evaporator replacement
  • Door, gasket, sweep and heater repairs
  • Defrost, drain and ice-up fault diagnosis
  • Temperature logging and high-temperature alarms
  • Servicing and repairs on rooms built by any installer

Signs it needs attention

  • !Ice on the ceiling, floor or door frame
  • !The room holds temperature at night but not during service
  • !Water leaking from under the evaporator
  • !The unit never stops running, or short cycles on defrost

Questions we get asked

How much space does a cold room need?

The internal size depends on stock volume and how the kitchen works in it. Just as important is space outside for the condensing unit and its airflow. We assess both before quoting, because plant squeezed into a hot service passage will not perform.

Can you repair a cold room installed by someone else?

Yes. We work on existing rooms regardless of who built them, including panel repairs, door hardware, controls and refrigeration plant.

Why does our cold room ice up so quickly?

Usually warm, moist air is getting in. A worn door gasket, a damaged sweep, a failed door heater or a defrost cycle that is too short will all do it. The fix is often in the room rather than in the plant.

Enquiry

Cold Rooms: request an assessment

Send the details of the cold rooms work and we will come back with a site visit, a quote or an honest alternative.

Property type
How soon

Your details go to info@reyds.co.za and appear in the Reyds dashboard. No marketing lists.